A3 Carbon Fiber Trim Production

Was able to find someone with an A3 that was willing to be a test mule and was able to make some progress on it this week.  It is only one piece on each door and the shifter plate, so there aren’t that many pieces to wrap.  Hopefully in the future we can find some other pieces in the A3 cockpit to wrap as well.

The fiber went on the pieces pretty easily as the door pieces are very simple.

After a few coats of resin, these pieces are set.  Should only take a few days to cure and I can start to trim them up and sand them smooth.

Leave a comment

Please note, comments must be approved before they are published