New compressor is all setup…

It took us a few days to get the spray booth setup, but its finally done.  We spent the majority of the day yesterday plumbing the new compressor to the new filter we picked up on Friday.  All the hard work has paid off with a leak free system.

Sam soldering the copper pipe.

Multiple shut off valves, as we’ll be plumbing more air lines to the rest of the shop when we have time.

We needed 25 feet of copper piping between the compressor and the filter so we had to improvise a little trap run.  The pipes are sloped so that condensation in the pipes flows towards the shut off valve at the bottom.

Good to go.  The air line from the filter will run directly into the spray booth.

Leave a comment

Please note, comments must be approved before they are published